|
|
Posts: 92
Location: oklahoma | Anyone had any problems with the fly wheel in a dodge 3500? Mine has 70K and is shaking bad I thought it might be an injector dealer says Fly wheel & clutch It shifts fine. I did some research and found where the computer can be adjusted so the cylinder can be balanced? Any input Thanks |
|
| |
|
Location: Colorado | I haven't seen that particular problem. I have seen a bad vibration dampener (mounted on the front of the crankshaft) cause that problem also. |
|
| |
|
Posts: 5
Location: wyoming | I have a buddy that had the same vibration and it acted like it would skip a beat. He took it in and the flywheel was cracked. They left the clutch alone. His also had about 70k on it. I think it should be covered under warranty but they say it is not part of the drive train. |
|
| |
|
Posts: 49
| Hello,
I have a 2006 Dodge 3500. at about 45,000 miles I had a vibration at low rpm. It turned out to be the flywheel. The hole on the flywheel that slides on the shaft was wore, which was causing the vibration.
|
|
| |
06 Dodge fly wheel problems
