Error encountered in: C:\HostingSpaces\admin1\workingtruckworld.com_38TBpd5h\wwwroot\forum\templates\original\fragments\template-begin.asp
Microsoft VBScript compilation error - Expected statement
chip for 2005 F250 deisel
Mouse1999
Reg. Nov 2006
Posted 2010-12-02 8:01 PM (#5132)
Subject: chip for 2005 F250 deisel





Posts: 24

was wondering what chip or programmer would be best for towing

Edited by Mouse1999 2010-12-02 8:02 PM
share Top of the page Bottom of the page
hogtownboss
Reg. Jan 2009
Posted 2010-12-03 1:07 PM (#5133 - in reply to #5132)
Subject: RE: chip for 2005 F250 deisel





Posts: 176

I have had good luck with the TS Performance Chips in all of the 7.3's and the 6.0's. They offer a 4 bank 6 pos. chip that allows you to adjust while driving.

On your 6.0, you need to be carefull when install more power unless you also do the egr and cooler deletes. If you do not do then you could be asking for head gasket problems down the road.

Go to www.powerstroke.org they have a section just for the 6.0 trucks and gives alot of info about the egr and cooler stuff. It is nothing major, just something worht looking into before it is too late. My opinion it is cheaper to make some adjustments before there is a problem. These deletes are anywhere from $350 to $750 depending on who does the work and headgaskets later is around $2500 or so.

Also Banks Power offer a simple plug in chip that add around 60hp for aoundd $250.00 to $300.00
share Top of the page Bottom of the page