Posted 2009-08-05 4:34 PM (#2496) Subject: 04 Ford Dually 6.0 won't start after repaced HG and EGR
Posts: 2
I've had my truck for a while now and it was running fine until the EGR cooler went bad. I replaced it wit the delete kit and found out that the head gasket was blown. So I replaced the head gaskets as well and put everyting back the way it was. At this point the truck wouldn't start. It would turn over but not fire, so I checked the code and read cam + crank sensor codes. I replaced them both and the truck will still not start. I've checked the fuel lines and diesel is getting to the injectors. If I spray starter fluid into the intake the truck will run until I stop sprayin it then it shuts right back off. I'm at the end of my witts. Somebody pls help me!!!
Posted 2009-08-10 1:25 PM (#2500 - in reply to #2496) Subject: RE: 04 Ford Dually 6.0 won't start after repaced HG and EGR
Posts: 176
1st off DO NOT USE STARTED FUILD on the 6.0's you will blow the heads off of the engine! Been there done that!
2) Check to make sure every SINGLE wire and plug you removed is plugged back in and make sure you did not smash it in the intake when reinstalling the heads or intake.
3) There is an oil plug or sensor that is on the back side of the intake that is hard to see, but make sure it is plugged in and there is no oil leaking form it.
If all else fails go to powerstroke.org and search in the 6.0 section.